A Couple Pics of My Bottle Mounting

[TSnoop05]

http://i936.photobucket.com/albums/ad207/tsnoop05/NitrousBottle.jpg
http://i936.photobucket.com/albums/ad207/tsnoop05/NitrousMount.jpg

[Jose93z28]

That's one badass bracket looks clean, easy access too.

[TSnoop05]

Thanks bud I had the bottle powder coated, in the sun it has some metallic in it, I want to get a Trans Am emblem on it eventually. I'll get some underhood pics up as soon as I clean up my install some more its a bit sloppy still for my liking.

[camaro408ss]

I like it.... new arm rest for the people in the back... HA!
Seriously though... looks great, i like the powder coating.

[TSnoop05]

Ha Yeah armrest thats the first thing I thought too. . . So I'm still pretty new to nitrous but I just got my bottle filled it only pushes 600-650 psi. Do I need to always have the bottle warmer on it to get 1000 psi or should the first few runs out of a full bottle have me at that? I haven't wired up my bottle warmer yet and was just wondering?

[camaro408ss]

You should always check the bottle first to see what it's doing.... You want between 900-1100 psi... And if you use the warmer.. Don't forget about it, bad things happen!

[DanDan]

Bottle looks good! What size shot are you running?

[Scuba_Steve]

Looks good, don't think it'll pass tech though if you go to the drag strip:hmmmm:

[Get Bit]

X2 ^^

[TSnoop05]

Yeah I wasn't sure if a full bottle should have more pressure on it than 600 without heating it up. My bottle warmer was missing the thermostats and I wasn't sure if it would be safe to run it without them? So far I've just shot a 75 shot but I will probably go to a 100 shot and call it good there. I also have a blowdown tube do you guys think I'll be able to pass inspection if I install it?

[99Superhawk]

Yes you need a blow down tube to pass tech. Otherwise you should be just fine.

[datzneat]

It doesn't look like you care about drilling holes in your car. But if don't want another hole you can remove one of the seat belt clips. The bolt goes clear through the body. Use another steel braided line and it'll stay clean. With the right connection you can screw it right into the hole. BTW nice color matching lol.

[TSnoop05]

Hey Thanks man that sounds like a good idea I know what you mean I had to take the clips out to remove the carpet to mark and drill my holes. I might do that and switch the side my feed goes out to the passenger side. I never have anyone sit behind the drivers seat but I think I'd like a seatbelt for the rear passenger if I do take someone.

[nstg8r]

Thanks bud I had the bottle powder coated, in the sun it has some metallic in it, I want to get a Trans Am emblem on it eventually. I'll get some underhood pics up as soon as I clean up my install some more its a bit sloppy still for my liking.

I can do this in vinyl if you are still wanting to do that, I wanted a bird for the center panel for my formula so I have a bird all setup and ready to cut.